SRSTONEY ROLATECHNOLOGY

CML-HA-MC-001

A motor replacement is a system decision.

Our initial program focuses on low-voltage BLDC fan-motor and controller alternatives for refrigeration, commercial cooling and air-treatment equipment.

THE PROBLEM

Too expensive. Too slow.
Too dependent on one source.

We support manufacturers, distributors and service organizations that need a technically controlled second source—not a visually similar motor from a generic catalogue.

Working with established manufacturing resources, including Nonstop and Lepu Motor, we can evaluate conventional, BLDC, stepper and geared-stepper motor requirements and related drive or interface customization.

Manufacturing-resource references do not imply ownership, authorization, exclusivity or guaranteed supply.
WHAT WE COMPARE
0112/24V DC input
025–30W initial range
03Speed and current
04Airflow / static pressure
05PWM or analog control
06FG feedback
07Protection logic
08Noise and temperature
09Connector and pinout
10Mounting and shaft geometry

CONTROLLED ENTRY

From evidence to a pilot—not from a claim to a bulk order.

  1. 01
    Submit the existing model

    Model, nameplate, photos, drawing or original sample.

  2. 02
    Freeze the acceptance baseline

    Electrical, mechanical, control, performance and operating conditions.

  3. 03
    Build and test samples

    Typical target: 5–20 units, subject to confirmed scope.

  4. 04
    Run a controlled pilot

    Batch supply follows only after customer-approved validation.

What we will not claim before evidence:pin-to-pin equivalenceguaranteed certificationlowest priceannual savingsfixed production lead time

MOTOR REVIEW

Send a nameplate photo.
We will start with the gaps.

Submit a motor for review ↗